How To Use A Clamp Meter
How To Use A Clamp Meter. Hands and fingers must always be kept behind the clamp meter’s tactile barrier (figure 3). This meter has an advantage over.

When current flows through a conductor, a magnetic field is generated. For experienced technicians, you can use your left hand to hold the clamp meter and the right hand for noting down measurements. Switch on the meter and make sure to remove the probes if they are attached.
Steps To Follow While Using A Fluke Clamp Meter 323.
Turn on the meter and remove the probes (if connected) step 2 : Testing the car battery with schumacher bt f250 clamp meter. Thereafter connect the electrical appliance to a power source.
For Experienced Technicians, You Can Use Your Left Hand To Hold The Clamp Meter And The Right Hand For Noting Down Measurements.
Cl320 with trms measurement technology measures ac current, ncvt, ac/dc voltage, resistance, frequency, dc microamps, capacitance, duty cycle, diode test, continuity, and temperature; Steps for measuring ac or dc current using a clamp meter's jaws: A secondary coil inside the body of the meter can determine the input current by reading the generated voltage over a small fixed load resistor.
The General Rule When It Comes To Using Clamp Meters Is To Set The Meter On The Desired Setting, Place The Clamp Around The Wire Or Leads On The Poles And Read The Measurement.
When using the clamp meter to measure with the jaws, both probes must be removed from the meter. What is a clamp meter? A clamp meter (clamp meter) is a portable meter that measures the current in a circuit by measuring the magnetic field strength around a single conductor.
The Jaws Of A Clamp Meter Do Not Need To Touch A Conductor During A Measurement.
This equipment is very simple to use and operate. A clamp meter is a device that is used to measure current conveniently and safely. The clamp meter is used to measure current in a circuit with currents greater than 1a and in applications where it can be easily placed around one of the conductors.
Special Care Must Be Taken When Dealing With Voltages Exceeding 60 Vdc Or 30 Volts Ac Rms For Increased Risks Of Shock.
Select the ac or dc function using the dial. Use the lever to open the jaw of the clamp meter and the place the conductor you wish to measure in between the jaws. Steps to follow while using a clamp meter to measure current step 1 :
0 Response to "How To Use A Clamp Meter"
Posting Komentar